![]() Given that the "simple" Silence Finder has been retained, I think it would be good to add a bit more functionality to "Sound Finder" as a more "advanced" option. It is too late to change Sound Finder in Audacity 2.4.0, but this delay provides an opportunity to fully test, and tweak if necessary, an updated effect for a future Audacity release. Label-sounds.png (51.76 KiB) Viewed 2465 times The name, as recommended by Apple's ' Human Interface Guidelines', uses the action verb "label", and is descriptive of what the effect does - it labels sounds. Average level: The threshold is measured as the absolute average level for each 100 ms.Peak level: The threshold level is measured as the peak level.Threshold measurement: (default "Peak level").When audio is below this level, it is considered to be 'silence'. This setting may helpĪvoid labelling clicks in vinyl recording. Like the 'Average level' measurement, this is less likely to RMS level: The threshold is measured as RMS level.Note that the average level will usually be lower than the peak level. Is found, preceding sound and following sound are considered to be separate sounds, provided that the previous When 'silence' of this duration (or longer) Minimum silence duration: (default 1 second).RMS level may be measured with the 'Measure RMS' or 'Contrast' effects. Minimum sound duration: (default 1 second).Sound is at least the 'Minimum sound duration'. This means that labels will be at intervals of this length or more, other than If a sound less than this length is interruptedīy silence, the silence will be ignored. Maximum leading silence: (default: 1 second)Ī point label, or the start of a region label will be placed before the start of a sound by this amount, if there is room to do so.Sounds are labelled either with a point label before the sound, or a region label around the sound. ![]() Maximum trailing silence: (default 1 second).Labels will not be placed before time=0, and will not overlap previous sounds. This setting is used by region labels only. Maximum number of labels: (default 99).The end of a region label will be placed this distance after the end of a sound, provided that there is room to do so before the next sound. The maximum number of labels that will be produced. Note that the maximum number of tracks for a normal audio CD is 99. This is the text that will be entered in each label. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |